Seagull Models Silence Twister Specifications download pdf (Page 23)

23

www.seagullmodels.com

4) When you are sure that everything is

aligned correctly, mix up a generous amount of

Flash 30 Minute Epoxy. Apply a thin layer to the

mounting slot and to bottom of the vertical sta-

bilizer mounting area. Apply epoxy to the bot-

tom and top edges of the filler block and to the

lower hinge also. Set the stabilizer in place

and realign. Double check all of your measure-

ments once more before the epoxy cures. Hold

the stabilizer in place with T-pins or masking

tape and remove any excess epoxy using a

paper towel and rubbing alcohol. Allow the ep-

oxy to fully cure before proceeding.

C/A glue.

A

AILERON PUSHROD HORN INSTALLATION

Mark.

Pen.

A

1) Mark the control wire where it crosses the

servo arm hole.

Bend at the mark.

Cut.

8mm.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Comments to this Manuals

No comments