Seagull Models Silence Twister Specifications download pdf (Page 14)

SILENCE TWISTER. Instruction Manual.

9) Move the throttle stick to the closed position

and move the carburetor to closed. Use a 2.5mm

hex wrench to tighten the screw that secures

the throttle pushrod wire. Make sure to use

threadlock on the screw so it does not vibrate

loose.

4) On the fire wall has the location for the

throttle pusshrod tube (pre-drill).

7) Slide the throttle pushrod wire into the tube.

Position the engine between the mounts. Use

four M4x30mm machine screws to secure the

engine to the mount as shown.

5) Slide the pushrod tube in the firewall and

guide it through the fuel tank mount. Use

medium C/A to glue the tube to the firewall and

the fuel tank mount.

6) Connect the Z-bend in the 450mm throttle

pushrod to the outer hole of the carburetor arm.

Machine screw M4x30mm.

Pushrod wire.

4.5mm.

4mm.

3) Use a drill to drill the four holes in the engine

mount rails.

8) Reinstall the servo horn by sliding the

connector over the pushrod wire. Center the

throttle stick and trim and install the servo horn

perpendicular to the servo center line.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 34 35

No comments

Seagull Models Silence Twister Specifications Page 14