Seagull Models Silence Twister Specifications download pdf (Page 15)

www.seagullmodels.com

+ ENGINE .91 - 1.2 : 4 STROKE.

150mm.

 1) Position the engine with the drive washer

(150mm) forward of the firewall as shown.

2) Use a pin drill and 4mm drill bit to drill a

small indentation in the mount for the engine

mounting screw.

4mm.

4) On the fire wall has the location for the

throttle pusshrod tube (pre-drill).

7) Slide the throttle pushrod wire into the tube.

Position the engine between the mounts. Use

four M4x30mm machine screws to secure the

engine to the mount as shown.

5) Slide the pushrod tube in the firewall and

guide it through the fuel tank mount. Use

medium C/A to glue the tube to the firewall and

the fuel tank mount.

6) Connect the Z-bend in the 450mm throttle

pushrod to the outer hole of the carburetor arm.

Machine screw M4x30mm.

4.5mm.

3) Use a drill to drill the four holes in the engine

mount rails.

Pushrod wire.

4.5mm.

8) Reinstall the servo horn by sliding the

connector over the pushrod wire. Center the

throttle stick and trim and install the servo horn

perpendicular to the servo center line.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 34 35

No comments

Seagull Models Silence Twister Specifications Page 15