Seagull Models Silence Twister Specifications download pdf (Page 20)

SILENCE TWISTER. Instruction Manual.

INSTALLING THE HORIZONTAL STABILIZER.

Draw center line.

 1) Using a ruler and a pen, locate the

centerline of the horizontal stabilizer, at the

trailing edge, and place a mark. Use a triangle

and extend this mark, from back to front,

across the top of the stabilizer. Also extend

this mark down the back of the trailing edge of

the stabilizer.

 2) Using a modeling knife, carefully remove

the covering at mounting slot of horizontal

stabilizer.

INSTALLING THE SPINNER.

Install the spinner backplate, propeller and

spinner cone.

The propeller should not touch any part

of the spinner cone. If it does, use a

sharp modeling knife and carefully trim away

the spinner cone where the propeller comes

in contact with it.

speed control.

5) Attach the speed control to the side of the

motor box using two-sided tape and tie wraps.

Connect the appropriate leads from the speed

control to the motor. Make sure the leads will

not interfere with the operation of the motor.

Tie wraps.

4) Locate the plywood battery tray to the

fuselage.

Battery.

Balsa stick.

140mm.

Epoxy.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 34 35

No comments

Seagull Models Silence Twister Specifications Page 20