Seagull Models 337 Skymaster Specifications download pdf (Page 3)

3

www.seagullmodels.com

KIT CONTENTS.

ADDITIONAL ITEMS REQUIRED.

 0.36-0.46 2-stroke engine

0.52 -0.72 4-stroke engine

 6 channel with 10 servos

 Glow plug to suit engine

 Push pull propeller to suit engine

 Protective foam rubber for radio

system

 Silicone fuel line

TOOLS & SUPPLIES NEEDED.

 Thick cyanoacrylate glue

 30 minute epoxy

 5 minute epoxy

 Hand or electric drill

 Assorted drill bits

 Modelling knife

 Straight edge ruler

 2mm ball driver

 Phillips head screwdriver

 220 grit sandpaper

 90° square or builder’s triangle

 Wire cutters

 Masking tape & T-pins

 Thread-lock

 Paper towels

HINGING THE FLAP .

The control surfaces, including the

ailerons, elevators, and rudder, are

prehinged with hinges installed, but

the hinges are not glued in place. It

is imperative that you properly

adhere the hinges in place per the

steps that follow using a high-quality

thin C/A glue.

Note:

 1) Carefully remove the flap from one of

the wing panels. Note the position of the hinges.

Hinge.

T-pin.

 2) Remove each hinge from the wing panel

and flap and place a T-pin in the center of each

hinge. Slide each hinge into the aileron until

the T-pin is snug against the aileron. This will

help ensure an equal amount of hinge is on

either side of the hinge line when the flap is

mounted to the wing panel.

 3) Slide the flap on the wing panel until

there is only a slight gap. The hinge is now

centered on the wing panel and flap. Remove

the T-pins and snug the flap against the wing

panel. A gap of 1/64” or less should be

maintained between the wing panel and flap.

1 Fuselage

2 Wing Set

2A Center Wing

3 Tail Set

4 Cowlings

5 Aluminum Wing Tube

1 2 3 4 5 6 7 8 ... 37 38

Comments to this Manuals

No comments