Seagull Models MXS-R User Manual download pdf (Page 27)

27

www.seagullmodels.com

Repeat the procedure for the other aileron servo.

 5) When you are satisfied with the align-

ment, hold the stabilizer in place with T- pins

or masking tape, but do not glue at this time.

 4) Install the stabilizer onto the fuselage.

Align the centerline drawn on the top and the

rear of the stabilizer with the centre of the fu-

selage. When that is aligned, hold the stabi-

lizer in that position using T-pins or masking

tape. Align the horizontal stabilizer with the

wing. When viewed from the rear, the hori-

zontal stabilizer should be level with the wing.

If it is not level, use sandpaper and sand down

the high side of the stabilizer mounting plat-

form until the proper alignment is achieved.

The tips of the stabilizer should also be equal

distance from the tips of the wing.

 3) Put the stabilizer into place in the

position of the fuselage.

Cut.

Remove the covering.

INSTALLING THE HORIZONTAL STABILIZER.

Draw center line.

 1) Using a ruler and a pen, locate the

centerline of the horizontal stabilizer, at the

trailing edge, and place a mark. Use a triangle

and extend this mark, from back to front,

across the top of the stabilizer. Also extend

this mark down the back of the trailing edge of

the stabilizer.

 2) Using a modeling knife, carefully remove

the covering at mounting slot of horizontal

stabilizer.

Hinge slot.

 6) With the stabilizer held firmly in place,

use a pen and draw lines onto the stabilizer

where it and the fuselage sides meet. Do this

on both the right and left sides and top and

bottom of the stabilizer.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 37 38

Comments to this Manuals

No comments