Seagull Models MXS-R User Manual download pdf (Page 17)

17

www.seagullmodels.com

COWLING.

 1) Slide the fiberglass cowl over the en-

gine and line up the back edge of the cowl with

the marks you made on the fuselage then trim

and cut as shown.

 2) While keeping the back edge of the

cowl flush with the marks, align the front of

the cowl with the crankshaft of the engine. The

front of the cowl should be positioned so the

crankshaft is in nearly the middle of the cowl

opening. Use the spinner backplate as a guide.

Hold the cowl firmly in place using pieces of

masking tape.

Because of the size of the cowl, it may be nec-

essary to use a needle valve extension for the

high speed needle valve. Make this out of suf-

ficient length 1.5mm wire and install it into the

end of the needle valve. Secure the wire in

place by tightening the set screw in the side of

the needle valve.

9) Move the throttle stick to the closed position

and move the carburetor to closed. Use a 2.5mm

hex wrench to tighten the screw that secures

the throttle pushrod wire. Make sure to use

threadlock on the screw so it does not vibrate

loose.

Cut.

Machine screw M3x10mm.

Needle valve.

 3) Install the muffler and muffler extension

onto the engine and make the cutout in the

cowl for muffler clearance. Connect the fuel

and pressure lines to the carburetor, muffler

and fuel filler valve. Secure the cowl to fuse-

lage using the 3x10mm screws.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Comments to this Manuals

No comments