Seagull Models Super chipmunk Size 55 Specifications download pdf (Page 5)

5

www.seagullmodels.com

 8) After both ailerons are securely hinged,

firmly grasp the wing panel and aileron to

make sure the hinges are securely glued and

cannot be pulled out. Do this by carefully

applying medium pressure, trying to separate

the aileron from the wing panel. Use caution

not to crush the wing structure.

 7) Repeat this process with the other wing

panel, securely hinging the aileron in place.

 6) Using C/A remover/debonder and a

paper towel, remove any excess C/A glue that

may have accumulated on the wing or in the

aileron hinge area.

 5) Turn the wing panel over and deflect the

aileron in the opposite direction from the

opposite side. Apply thin C/A glue to each

hinge, making sure that the C/A penetrates into

both the aileron and wing panel.

Work the aileron up and down several

times to “work in” the hinges and

check for proper movement.

Note:

Aileron control horn.

INSTALL THE AILERONS CONTROL

HORN.

1) Locate the hardware necessary to install

the control horns for the ailerons.

HINGING THE ELEVATOR.

Glue the rudder hinges in place using the

same techniques used to hinge the ailerons.

Fiberglass control horn.

2)Position the Control horn on the Aileron

and use 30-minute Epoxy

Epoxy.

1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments