Seagull Models Super chipmunk Size 55 Specifications download pdf (Page 10)

SUPER CHIPMUNK SIZE 55. Instruction Manual.

8) Reinstall the servo horn by sliding the

connector over the pushrod wire. Center the

throttle stick and trim and install the servo horn

perpendicular to the servo center line.

9) Move the throttle stick to the closed position

and move the carburetor to closed. Use a 2.5mm

hex wrench to tighten the screw that secures

the throttle pushrod wire. Make sure to use

threadlock on the screw so it does not vibrate

loose.

3) Use a drill to drill the four holes in the engine

mount rails.

4) On the fire wall has the location for the

throttle pusshrod tube (pre-drill).

2mm.

Machine screw M3x25mm.

7) Slide the throttle pushrod wire into the tube.

Position the engine between the mounts. Use

four M3x25mm machine screws to secure the

engine to the mount as shown.

5) Slide the pushrod tube in the firewall and

guide it through the fuel tank mount. Use

medium C/A to glue the tube to the firewall and

the fuel tank mount.

6) Connect the Z-bend in the 450mm throttle

pushrod to the outer hole of the carburetor arm.

Pushrod tube hole.

Drill 4mm.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Seagull Models Super chipmunk Size 55 Specifications Page 10