Seagull Models Extra 260 Specifications

Kit features.• Ready-made—minimal assembly & finishing required.• Ready-covered covering.• Photo-illustrated step-by-step Assembly Manual.Made in

EXTRA 260. Instruction Manual.10! 8) After the epoxy has fully cured, re-move th

www.seagullmodels.com11Hinge slot.! 1) Using a modeling knife, remove thecovering from over the precut hinge slot cutinto the lower rear portion of th

EXTRA 260. Instruction Manual.12INSTALLING THE AILERON LINKAGE.! 1) Ailero

www.seagullmodels.com13 Repeat the procedure for ortherelevator.! 1) Position the rudder control horn on theleft - right side of the rudder.! 2) Lo

EXTRA 260. Instruction Manual.14! 2) With the radio on, check the operationof th

www.seagullmodels.com15 WHEEL AND WHEEL PANTS.! 2) Follow diagram below for wheel pantinstallation:! 1) Assemble and mounting the wheel pantsas sh

EXTRA 260. Instruction Manual.16Landinggear.! 4) A drop of C/A glue on the

www.seagullmodels.com17! 6) Attach the Z-Bend in the pushrod wire tothe throttle arm on the carburetor. You will needto remove the throttle arm from

EXTRA 260. Instruction Manual.18! 3) Install the muffler and muffler extensionon

www.seagullmodels.com19INSTALLING TAIL STRUT SYSTEM. Tail strut system assembly follow picturesbelow.3x10mm.3.2mm drill bit.Turnbuckle.Horizontal s

EXTRA 260. Instruction Manual.2INTRODUCTION. Thank you for choosing the EXTRA

EXTRA 260. Instruction Manual.202133mm.MOUNTING THE TAIL WHEEL.! 2) Set the tai

www.seagullmodels.com21Tie wrap.Receiver.! 2) Install the rubber grommets and brasscollets onto the throttle servo. Test fit the servointo the thrott

EXTRA 260. Instruction Manual.22 Insert two wing panels as pictures below:ATT

www.seagullmodels.com23! 4) By moving the position of the adjust-able control horn out from the control surface,you will decrease the amount of throw

www.seagullmodels.com3Please contact Horizon Hobby for product supportand technical assistance at 877-504-0233.Replacement parts are available from yo

EXTRA 260. Instruction Manual.4The control surfaces, including theailerons, elev

www.seagullmodels.com5Work the aileron up and down severaltimes to “work in” the hinges and checkfor proper movement.HINGING THE ELEVATOR.Note:! 8) A

EXTRA 260. Instruction Manual.6Vent tube.Fuel Pick-up Tube.Fuel Fill Tube. Car

www.seagullmodels.com7Fuel pick-uptube.Fuel fill tube.Vent tube.Blow through one of the lines to ensurethe fuel lines have not become kinked insidethe

EXTRA 260. Instruction Manual.8Wing bottom.Thread.Small weight.Thread.Small weig

www.seagullmodels.com9Wing bottom.HORIZONTAL STABILIZER. Attach the string to the servo lead andcarefully thread it though the wing. Once youhave