Seagull Models PERCIVAL MEW GULL Specifications download pdf (Page 7)

www.seagullmodels.com

7

 4) Test fit the stopper assembly into the

tank. It may be necessary to remove some of

the flashing around the tank opening using a

modeling knife. If flashing is present, make

sure none falls into the tank.

 5) With the stopper assembly in place,

the weighted pick-up should rest away from

the rear of the tank and move freely inside the

tank. The top of the vent tube should rest just

below the top of the tank. It should not touch

the top of the tank.

 6) When satisfied with the alignment of

the stopper assembly tighten the 3 x 20mm

machine screw until the rubber stopper ex-

pands and seals the tank opening. Do not

overtighten the assembly as this could cause

the tank to split.

FUEL TANK INSTALLATION.

You should mark which tube is the vent

and which is the fuel pickup when you

attach fuel tubing to the tubes in the stopper.

Once the tank is installed inside the fuselage,

it may be difficult to determine which is which.

Rubber band.

Fuel tank.

Blow through one of the lines to ensure

the fuel lines have not become kinked in-

side the fuel tank compartment. Air should

flow through easily.

 1) Using a modeling knife, remove the

covering from over the two main gear mount-

ing slots located in the bottom of the wing.

Vent tube.

Fuel fill tube.

Fuel pick-up tube.

A .

B

1_Glow Engine.

INSTALLING THE BATTERY.

Battery.

INSTALLING THE MAIN GEAR WIRES

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments